Measuring volume density of working layer of ceramic superhard abrasive tools

XING Bo; LI Bingwen; CHEN Xuewei; ZHANG Linzhou; CHEN Xuebin; ZHAO Yanjun; YAN Ning

doi:10.13394/j.cnki.jgszz.2019.3.0014

Volume 39 Issue 3

Jun. 2019

Turn off MathJax

Article Contents

Article Navigation > Diamond & Abrasives Engineering > 2019 > 39(3): 88-92

XING Bo, LI Bingwen, CHEN Xuewei, ZHANG Linzhou, CHEN Xuebin, ZHAO Yanjun, YAN Ning. Measuring volume density of working layer of ceramic superhard abrasive tools[J]. Diamond & Abrasives Engineering, 2019, 39(3): 88-92. doi: 10.13394/j.cnki.jgszz.2019.3.0014

Citation:

XING Bo, LI Bingwen, CHEN Xuewei, ZHANG Linzhou, CHEN Xuebin, ZHAO Yanjun, YAN Ning. Measuring volume density of working layer of ceramic superhard abrasive tools[J]. Diamond & Abrasives Engineering, 2019, 39(3): 88-92. doi: 10.13394/j.cnki.jgszz.2019.3.0014

Citation:

PDF( 1118 KB)

Measuring volume density of working layer of ceramic superhard abrasive tools

doi: 10.13394/j.cnki.jgszz.2019.3.0014

XING Bo^1,2,3,
LI Bingwen^1,2,3,
CHEN Xuewei^1,2,3,
ZHANG Linzhou^1,2,3,
CHEN Xuebin^1,2,3,
ZHAO Yanjun^1,2,3,
YAN Ning^1,2,3

1. Zhengzhou Research Institute Abrasives & Grinding Co., Ltd., Zhengzhou 450001, China;
2. State Key Laboratory of Superabrasives, Zhengzhou 450001, China;
3. National Quality Supervision and Inspection Center for Abrasives, Zhengzhou 450001, China

More Information

Rev Recd Date: 2019-05-20

Available Online: 2022-04-06

Abstract

Abstract

According to JB/T 7999—2013 “Bonded abrasive products—Testing methods for the volume density, general porosity and water absorption”, the volume density of working layer of ceramic superhard abrasive tools was measured, and the influencing factors were analyzed.The results show that when measuring, the sampling quantity should be more than 0.50 g, the sample quantity decreases, the testing results show a downward trend.When the volume density of the sample exceeds 2.85 g/cm³, the vacuum treatment procedure can be omitted. When the volume density ranges from 2.50 to 2.85 g/cm³, the vacuum treatment operation can be changed to soak in deionized water for 1 hour.When the volume density is less than 2.50 g/cm³, it needs to be vacuum treated.
- ceramic superabrasive section,
- volume density,
- vacuum pumping