Study on coating layer of resin bonded diamond wire saw

ZHENG Lu; GE Peiqi; BI Wenbo; YUAN Guoqiang

doi:10.13394/j.cnki.jgszz.2016.3.0002

Volume 36 Issue 3

Jun. 2016

Turn off MathJax

Article Contents

Article Navigation > Diamond & Abrasives Engineering > 2016 > 36(3): 6-10

ZHENG Lu, GE Peiqi, BI Wenbo, YUAN Guoqiang. Study on coating layer of resin bonded diamond wire saw[J]. Diamond & Abrasives Engineering, 2016, 36(3): 6-10. doi: 10.13394/j.cnki.jgszz.2016.3.0002

Citation:

ZHENG Lu, GE Peiqi, BI Wenbo, YUAN Guoqiang. Study on coating layer of resin bonded diamond wire saw[J]. Diamond & Abrasives Engineering, 2016, 36(3): 6-10. doi: 10.13394/j.cnki.jgszz.2016.3.0002

ZHENG Lu, GE Peiqi, BI Wenbo, YUAN Guoqiang. Study on coating layer of resin bonded diamond wire saw[J]. Diamond & Abrasives Engineering, 2016, 36(3): 6-10. doi: 10.13394/j.cnki.jgszz.2016.3.0002

Citation:

ZHENG Lu, GE Peiqi, BI Wenbo, YUAN Guoqiang. Study on coating layer of resin bonded diamond wire saw[J]. Diamond & Abrasives Engineering, 2016, 36(3): 6-10. doi: 10.13394/j.cnki.jgszz.2016.3.0002

PDF( 963 KB)

Study on coating layer of resin bonded diamond wire saw

doi: 10.13394/j.cnki.jgszz.2016.3.0002

ZHENG Lu¹,
GE Peiqi^{1,2
,
,},
BI Wenbo¹,
YUAN Guoqiang¹

1. School of Mechanical Engineering, Shandong University, Jinan 250061, China;
2. MOE Key Laboratory of High Efficiency and Clean Mechanical Manufacture, Shandong University, Jinan 250061, China

More Information

Rev Recd Date: 2016-03-15

Available Online: 2022-07-27

Abstract

Abstract

In order to overcome the deficiencies of resin bonded diamond wire saw,such as low abrasive holding strength,poor wear resistance and heat resistance,new experiment is carried out by using different coating layer components through orthogonal experiments.It is also studied that the effect of components on performance of the wire saw by cutting mono-crystalline silicon.Resultsshow that the optimal parameters in the components are mass ratio of epoxy resin and phenolic resin 2.5:1,toughening agent CTBN 13wt%,coupling agent KH-550 1wt%,nano-SiO₂ particle 3wt%,and the content of diamond abrasive 500 mg/mL.In this condition,the resin bonded diamond wire saw made in this condition has better comprehensive performance in terms of material removal rate,wear rate,coating layer bonding force and cutting quality of workpiece.
- resin bonded diamond wire saw,
- coating layer,
- orthogonal experiment